HO- 7286 Tuningkit for turntable from märklin/fleischmann

Model:

The Lasercut kit is intended for the optical improvement of the turntable (märklin7286 or fleischmann 6152) and consists of "bottoms" for the turntable and the surrounding boardwalk and a new cottage. This is based on the Gelsenkirchen-Bismarck cottage. The aim was not to damage the model as much as possible and to enable it to be dismantled. Therefore no new railings were made. The original house can be clipped out and taken off and will be replaced by the new building. Therefore a "flexible, removable adhesive" should be used here.

The previous plastic floors are newly covered with a floor approx. 0.45 mm thick.
In order to achieve a realistic structure, all floors are finished with our precision engraving in real wood look (similar to our load floors).

The pictures show a comparison between the previous floor covering and the glued !

The model/kit consists of :

1. to optimize the turntable:
   2x floor coverings for the turntable itself and 48 components for the surrounding boardwalk.  (Basic version)

2. turntable house:
   this kit contains the turntable house ! green house !

The kit captivates by:

• Precision engraving of the wood structure with the effect of peeling paint on the turntable house and the impregnation of the floors   
• Precision engraving in genuine wood optics for all floors  
• Precision engraving for us means a scale and realistic wood structure.
• Green house design

Attention: when upgrade the turntable with further tracks and additions:
if there are additional branches installed, you will need additional inserts for the plank path in the track for these track sections.
 
  --> For märklin / AC-version fleischmann:
is the number = for the not passable blind tracks at märklin > 10 so our article #7287 is necessary once for each further 6 "blind tracks".

  --> for DC-version Fleischmann:
our article number #7287 is required for each extension/addition set beyond the basic version (passable/non passable tracks).

Assembly instructions: that's how simple it is to assemble: Instructions

Please note: The turntable itself is not part of the order. This also applies to the colour certificates, figures, etc. shown. The finished kit shown in the picture is a design suggestion.

Hint:
When assembling the cardboard kit, please use only white glue which does not contain any admixtures such as quartz sand. These automatically lead to unwanted gaps !  For this reason we recommend "Bindan RS". (with which we have gathered the best experience), which you can also order from us.
With the kits you only need very (!) little glue, because we connect flat parts with each other. A light wetting is enough.
Window glass is glued with commercially available all-purpose adhesive.